4
Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net
❑
Kwik Bond Thin C/A # 887500
❑
Kwik Bond Thick C/A # 887510
❑
Kwik Bond 5 Minute Epoxy # 887560
❑
Kwik Bond C/A Debonder # 887545
❑
# 1 Phillips Head Screwdriver
❑
7/64" Hex Wrench
❑
Magnum Z-Bend Pliers # 237473
❑
Wire Cutters
❑
Needle Nose Pliers
❑
Excel Modeling Knife # 692801
❑
Scissors
❑
Electric Drill
❑
Assorted Drill Bits
❑
Ernst Airplane Stand # 223977
❑
Ruler
❑
Pencil
❑
Builder's Triangle
❑
220 Grit Sandpaper w/Sanding Block
❑
Dubro T-Pins # 567677
❑
Masking Tape
❑
Scotch
®
Tape
❑
Paper Towels
❑
Rubbing Alcohol
❑
NHP Epoxy Mixing Sticks # 864204
❑
NHP Epoxy Mixing Cups # 864205
❑
Emerald Motor Spray # 340186 (optional)
❑
Trinity Break-In Drops # 840768 (optional)
❑
Rubber Bands (optional)
This section lists the items you will need to purchase for your new Fokker Eindecker. These suggestions are not set in
stone, but they should provide you with a good starting point.
OUR RECOMMENDATIONS
TOOLS AND SUPPLIES REQUIRED
If you already have a radio system:
Hitec 555 Micro Receiver
Hitec RX Crystal
P/N 444227 Cirrus CS-21 Micro Servos (2)
P/N 128484 Wattage IC-15A ESC
P/N 128522 Wattage 8C 600Mah NiCD Flight Battery
P/N 130103 Wattage 1 amp AC/DC Peak Charger
P/N 869020 Dubro Double-Sided Tape
optional
P/N 128524 Wattage 8C 800Mah NiMH Flight Battery
If you don't have a radio system:
Hitec Focus 3 AM Radio Control System
P/N 444227 Cirrus CS-21 Micro Servos (2)
P/N 128484 Wattage IC-15A ESC
P/N 128522 Wattage 8C 600Mah NiCD Flight Battery
P/N 130103 Wattage 1amp AC/DC Peak Charger
P/N 869020 Dubro Double-Sided Tape
optional
P/N 128524 Wattage 8C 800Mah NiMH Flight Battery
IMPORTANT
When purchasing the Hitec 555 Micro receiver, be sure it is compatible with your transmitter. When purchasing the
crystal, make sure that it is on the same frequency as your transmitter.