• You can charge the battery by plugging the USB cable into
any of the power supplies listed below:
• A computer
• A USB wall-charger with an output of 5 volts and 1 amp
• A DC car-charger with an output of 5 volts and 1 amp
• It takes about 1-2 hours to fully charge the battery. Try not to
let the battery completely run out before charging. Charge as
needed.
• Remaining battery power percentage can be viewed via the
Acaia apps.
Turn on the
Acaia Pyxis.
Make sure the scale
is in the weighing
mode and the unit
is set to ‘gram’, then
tap ‘T’ button rapidly.
Keep tapping ‘T’
button until ‘CAL’ is
shown on the
display.
Place a 100 g weight
on the scale and wait
until the display shows
‘_End_’.
Calibration is now
complete.
Product Care Information
Turn on scale
Tap T button
Scale displays “CAL”
Place a weight
Charging the battery
Calibration
5
* Note: Using a non-certified charger could damage your Acaia scale’s circuit board or battery.
