1) PTZ PROTOCOL:
PELCO-P, PELCO-D
If the channel corresponds to a PTZ camera, setting the correct protocol allows control of
the PTZ camera.
2) PTZ BAUDRATE:
2400,4800,9600,19200,38400,115200
If the channel corresponds to a PTZ camera, setting the correct baudrate allows control of
the PTZ camera.
3) PTZ PANSPEED:
High,Middle,Low
If the channel corresponds to a PTZ camera, setting the pan speed allows control of the
PTZ camera.
4) PTZ TILTSPEED:
High,Middle,Low
If the channel corresponds to a PTZ camera, setting the tilt speed allows control of the
PTZ camera.
5) DEINTERLACE:
ON,OFF
To turn on or off the deinterlace of the PTZ camera.
6) MASK
Some of important area would not be seen during the DVR recording. With the mask you
can remove some parts of the view from the active motion detection area.
34
