2.2 Rear Panel
1. 8/16CH Video Inputs
8/16 channel composite video inputs with BNC connectors. NOTE:NTSC and PAL video
sources for 8/16CH video inputs can not be mixed. If they are mixed, DVR can’ not be
operated properly.
2. 8/16CH Loop through outputs
8/16 channel composite video outputs with BNC connectors. If the connection of loop-
through video outputs into another video equipments is requested, 8/16CH Loop-
through outputs can be utilized for it.
3. Video Outputs: 2 BNC, 1 S-Video & 1 VGA
the BNS connector marked “MONITOR”, S-Video and VGA output are used for main
monitoring. The other BNC connector marked “CALL” is used for spot monitoring, which
displays all of connected video channels sequentially and pop up the channel with event
triggered.
4. 2CH Audio input (RCA) and 1CH Audio Output (RCA)
Audio signal input and output with RCA jack. Connect the audio source to audio input
and audio output to your amplifier because the DVR don’t amplify audio output. A
speaker with an amplifier will be needed for audio playback. The audio input can be
from an amplified source or directly from a microphone.
5. Ethernet Port
Connect a Cat5 cable with an RJ-45 jack to the DVR connector. Remote PC viewer
software via network enables you to access live viewing and other available functions.
6. eSATA Port for External Storage Expansion
eSATA device like RAID system is supported for storage expansion, you can connect it
to eSATA port via eSATA cable. Make sure that you have turned on the eSATA external
storage device before DVR power on.
7. Alarm input and relay output
8/16 alarm inputs and 2 relay output with NO, NC.
8. Fan
System Fan.
9
