3.2.4 Windows NT Environment
Install Driver When You Are First Time to Setup Windows NT into Your
System
AEC671x.SYS is designed for Microsoft Windows NT miniport drivers.
This driver allows connection of SCSI devices (supported by Microsoft).
1. Insert Windows NT boot disk and boot from floppy disk.
2. Follow the Windows NT setup procedure.
3. Press“S” to skip mass storage devices detection.
4. Press“S” to specify additional SCSI adapter.
5. Move the highlight bar the Other and press “Enter”.
6. Please insert the AEC671x DISK1 into floppy drive A.
7. The ACARD Miniport driver should be highlighted. Press “Enter” to
proceed.
8. NT should now recognize the ACARD Miniport driver and the SCSI
hardware. Then, follow the Microsoft Windows NT installaiton.
9. Setup program will ask to insert driver disk, please insert DISK1 into
floppy drive A.
Install Driver for Windows NT
When Windows NT have been installed and you want plug the ACARD
SCSI device on the Windows NT system, you must use the ADD SCSI
Controller” method by following.
ADD SCSI driver from Windows NT 3.51
1. Main
2. Windows NT Setup
→
press < Option >
3. Add/Remove SCSI Adapters
→
press < Add >, then <OK>
4. Select SCSI Adapter Option
→
select < OTHER >
→
press < Install >
At the moment, insert the newest AEC671x driver diskette to
drive A, type directory A:\WINNT, and press < OK >
Chapter 3 Software Configuration
21
