AEC-6712TU
6
Chapter 2 Installation
2.1 Installation
The AEC-6712TU factory default setting will meet your needs without
modification in most case. If you need to modify the configuration,
please run the BIOS SETUP by the following installation procedure.
At first, chosen the cables match the environment you need; then mount-
ing hardware for the SCSI device and setting the terminators. (See
Figure 1.1)
Now, be sure the system power is off and plugs this host adapter into the
PCI slot then secure board via screw. Power up the system, it’s will boot
normally then you can setup the SCSI device via BIOS SETUP. The
follows install procedure is determine the OS that you chosen.
2.2 Board layout
CN 1
CN 2
CN 4
U1
ACARD
AEC876U-A
U2
Figure 1.1
AEC-6712TU Borad Layout
