AEC-6885 User’s Manual
12
3.1.2 Build Mirror Disk
When changing a mirrored hard drive, you can rebuild the hard drive’s data by
“Build Mirror Disk” according to the prompt upon booting. Please see 3.2.2.
3.1.3 Quick Erase Disk
This function allows you to quickly erase the data on a selected hard drive. Beware
that the data and the partitions will be completely erased.
3.1.4 RAID Mode Help
This function chiefly tells you that RAID 0+1 must be composed of 4 Master or 4
Slave hard drives. In other words, the hard drives must be set alike.
3.1.5 Card Information
This function indicates the I/O address, ROM address and IRQ number currently
used by AEC-6885.
3.1.6 Set Boot Disk
This function lets you select a hard drive or a pair of hard drives containing OS to
boot. But you need to enter BIOS of the motherboard, then boot “Other Boot De-
vice”. If a hard drive has been set as boot disk, there will be a * appearing before its
model number as Figure 3-1 shows.
3.2 Setting of RAID Mode
NOTICE: The rebuilding time depends on the size of RAID. You can press
Ctrl + S to stop rebuilding.
AEC-6885 supports RAID 0, 1, 0+1 and JBOD modes. The hardware setting re-
lated to each RAID mode is briefly described below. Yet, you are suggested to use
the AEC-6885 RAID Utility to set RAID. Please refer to Chapter 5 and Appendix A.
