ACC WF-100 Smartouch Wifi, Installation And Operational Manual

How to factory reset your WF-100 Wifi Module

There are several reasons that you may need to reset the unit and apply new settings. 

The following conditions will require you to reset and reconfigure your spa wifi unit:

A) Wifi router has been replaced or factory reset
B) Router Wifi access password has been changed

1. Leave the system powered on for this procedure. There is no shock hazard exposure 

during this procedure. You will be exposing the wifi circuit board, so make sure it does not
get wet or anything spilled on it!

2. Unmount the WF-100 wifi enclosure and remove the 4 corner screws on the back.
3. Carefully remove the front cover and locate the 2 white reset buttons along the edge of the 

board. The reset button right next to 3 green LEDs is the factory reset. The other button does a 
partial reset.

4. Press and hold the reset button closest to the 3 LED lights for 5 seconds or until all three LEDS 

light up, then go out and begin flashing (approximately 5-7 seconds). Release the button and 
wait for the reset to complete.

5. Now press the second button and immediately release.
6. Refer to 

Configuring Wifi settings section: starting at step 3 and perform the remaining 

setup process.

If you need any technical assistance, call us at 800-679-7727