3
2.1.1. CD-RW (Option)
The AV300seires system can select the CD-RW as Option. Use the CD-RW to backup the recorded image. Refer to
“Image Backup” for detail explanation.
2.1.2. Network LED
LED is blue when the system is connected to any network client (RemoteAgent). Light is automatically out when all clients
are disconnected.
2.1.3. Alarm LED
LED is lit if the system’s connected Alarm activates.
2.1.4. HDD LED
LED is blue when the camera image is being stored into or retrieved from the HDD. So, even though the system is
continuously recording, the HDD LED is only lit when actual data is recorded in the HDD. Usually, the LED will be flickering,
and this is normal.
2.1.5. Power LED
Show the power input and status of the system. The LED is red when the system is in stand-by position, but is green
when the system is working and power is being supplied.
2.1.6. USB Port
Use to backup recorded images of the AV300 series by using USB storage device. System software upgrade is possible
with USB storage device.
2.1.7. Remote Controller Receiver
AV300 can be operated conveniently, using the remote controller. Receives input signal from the remote controller
2.1.8. Power Button
Connect the power cable of the product before pressing this button to turn the power on and off.
2.1.9. Select Channel
These buttons are used to change the channel images. Left/Right button is used to change the channel on 1- screen
mode or PIP mode and Up/Down button is used to change PIP channel from PIP mode. Also, these buttons are used to
move cursor in “Setting” mode as up, down, left, or right, and also used to increase or decrease the setting value.
2.1.10. ENTER Button
The [Enter] button is used to go to the next stage, select value or settings.
2.1.11. RETURN Button
Use to cancel the password just typed at the setting menu or return to previous menu.
2.1.12. SETUP
Set the environment of the AV300 system according to the user requirement. Refer to “Setting” for detailed explanation.
2.1.13. Screen Mode Selection
Screen mode can be selected from the monitor screen. Whenever the buttons is pressed, it will change in
sequence in 1, 4, 8 and PIP screen.
Summary of Contents for AV304
Page 1: ......
Page 5: ......
Page 41: ...35 Input a new password After inputting password input the same password again...
