Accele HD Mobile DVR-720P USER MANUAL
[1]
Safety Tips & Instructions
Before installing and using, please read
the following warnings carefully.
Please read this
before installing
and using.
Please keep this
manual for
future reference.
The Accele Mobile DVR-720P uses a DC power supply; voltage input
range is 8V-36V. Please be sure to pay attention to 12V and GND
when connecting the power. Backwards connections could cause
DVR to short-circuit.
Please install a 15A fuse in line with the 12v wire to avoid short
circuits and possible equipment damage.
From the power supply to DVR, all power cables must be able to
withstand more than 60Watts. For example, when the vehicle power
supply output voltage is 12V, the source line must be able to
withstand 5 Amps or more.
Please install the equipment in a dry environment; avoid damp
areas, areas where water may drip or spray, etc.
To extend the life of the equipment, please install in a safe place,
away from moving parts and excessive vibration.
The equipment should be installed in the vehicles interior, in a well
ventilated area; DO NOT install in a location with no ventilation.
Please ensure that the equipment is away from any direct heat
sources in the vehicle cabin to avoid possible overheating and
device failure.
Please install in a location that ensures that passengers and/or
drivers cannot interfere with and damage any component(s) of the
device.
It is recommended that the power cord be wrapped in heat shrink
or similar wire protection material, which will help to prevent a
short circuit or disconnection.
PLEASE DO NOT OPEN THE DEVICE. DEVICE CONTAINS NO USER
SERVICEABLE PARTS INSIDE.
