Accent 1400 Hardware Manual for Dedicated Devices
Page 18
Applying a Screen Protector
If you plan to use a screen protector, you must first remove the device frame. To remove the frame, see
“Removing or Replacing the Device Frame” on page 19.
There are six screen protectors in the kit. Three have a matte finish and three have a luster finish. The
matte finish offers the most glare resistance. Matte protectors can be identified by the small red square
on the backing.
1.
Turn your device off and lay it flat on a table.
2.
Remove dust and fingerprints from the screen using a lint-free cloth dampened with water or flat-
screen TV cleaner.
Hint:
Do not dry the screen before applying the screen protector. You may find it easier to smooth
out the protector and remove air bubbles (step 7 below) if the screen is slightly damp.
3.
Peel a screen protector from its backing.
4.
Hold the protector along the edges with the side that was against the backing facing the screen.
5.
Align one edge of the protector with one edge of the screen.
6.
Press the protector onto the screen, adjusting the protector until it covers the screen along all edges.
7.
Use the squeegee included to smooth out the protector and remove air bubbles and wrinkles.
8.
Wipe the protector with a lint-free cloth to remove any fingerprints.
Hint:
Regularly wipe off the protector with a damp lint-free cloth to remove fingerprints, smudges, etc. If
the protector becomes too dirty, peel it off and replace it with a new protector.
