TRK2XX Initiation Manual
13
2. Ensure to use Saft LS14500 or compatible 3.6 V Primary lithium-thionyl chloride battery.
If any doubt please contact Accent Systems.
3. Use the same batch batteries, do not mixed used batteries with new ones.
4. Insert the batteries in the correct position as is shown in figure 4.
Figure 4 - TRK210 battery compartment with the batteries in the right position. Blue arrows
mark positive pole and orange arrows mark negative pole.
10.Battery recharging (only for TRK230 model)
For TRK230 the steps to recharge batteries are:
1. Open USB lid
2. Insert a Micro USB plug. The power supply current have to be 2 A.
3. Refer to section 7 of this document to know the battery charge status via RGB LED.
