Manual PCIe-DIO-120/96/72
8
Chapter 2: Installation
A printed Quick-Start Guide (QSG) is packed with the card for your convenience. If
you’ve already performed the steps from the QSG, you may find this chapter to be
redundant and may skip forward to begin developing your application.
The software provided with this card is normally downloaded from the product page at
accesio.com, or optionally on CD, and must be installed onto your hard disk prior to use.
To do this, perform the following steps as appropriate for your operating system.
Configure Card Options via Jumper Selection
Before installing the card into your computer, carefully read Chapter 3: Option Selection
of this manual, then configure the card according to your requirements. Our Windows
based setup program can be used in conjunction with Chapter 3 to assist in configuring
jumpers on the card, as well as provide additional descriptions for usage of the various
card options.
CD Software Installation
The following instructions assume the CD-
ROM drive is drive “D”. Please substitute the
appropriate drive letter for your system as necessary.
Windows
1.
Place the CD into your CD-ROM drive.
2.
The system should automatically run the install program. If the install program
does not run promptly, click START | RUN and type
, click OK
or press
.
3.
Follow the on-screen prompts to install the software for this board.
Linux
1.
Please refer to linux.htm on the CD-ROM for information on installing under linux.
Caution! * ESD
A single static discharge can damage your card and
cause premature failure! Please follow all reasonable
precautions to prevent a static discharge such as
grounding yourself by touching any grounded surface
prior to touching the card.
