2
4
2
CERTIFICATION:
ETL DRY
NO.
63961LEDD
3
MAKE WIRE CONNECTIONS
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts.
Connect the white supply wire to the white fixture
wire. Secure with the supplied wire nuts. Either
wrap the green wire around one of the protruding
screws or connect it to the supply ground wire.
Secure all wires with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
MOUNT THE BACK PLATE AND INSTALL
GLASS SHADES
Position the fixture plate over the crossbar plate.
Align the centre holes of the plate. Secure with the
supplied screw knobs.
Install the glass shades over the LED module by sliding
one side of the glass shade and then the other side,
gently under the clips.
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION
