CERTIFICATION:
cULus WET
PREPARE THE FIXTURE AND INSERT THE BULBS
If there is an existing fixture remove it. Expose the supply
wires from the J-box and pass the wires through the
designated hole in the universal plate rubber, gasket and
fixture back plate. Mount the universal plate, rubber gasket
and back plate with the supplied screws. Unscrew the two
screws on the top and bottom of the fixture that are securing
the glass covers to the fixture.
Insert the bulbs into each socket.
DO NOT EXCEED THE MAXIMUM WATTAGE
AS STATED ON THE WARNING LABEL.
Replace the glass covers and secure with supplied screws.
MAKE WIRE CONNECTIONS
Connect the black supply wire to the black fixture wire.
Secure with the supplied wire nuts. Connect the white supply
wire to the white fixture wire. Secure with the supplied wire
nuts. Attach the green J-Box wire around green hexagonal
head screw or connect it to the green supply grounding
wire of the fixture. Secure all wires with electrical tape (not
supplied). Tuck all wires carefully into the J-box.
MOUNT THE FIXTURE
Place the fixture canopy over the fixture back plate such
that the fixture is flush against the wall. Insert the supplied
screws into the holes in the fixture canopy ensuring that they
fit into the indented area on the back plate.
*This fixture is wet location rated. In order to ensure that
moisture does not enter the outlet box and cause a short
circuit, clear caulking should be used to seal the space
between the fixture mounting bracket and the wall.
Ensure that a space is left at the bottom to allow the
escape of moisture. It is recommended that
Indoor/Outdoor Silicon Sealant be used for this
purpose**
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
2
Dimmable fixture - see attached list for compatible dimmer switches.
VER: 17.10.1
2
3
4
1
NO.
20389LEDDMGLP
