1.
Start the engine and warm it up to normal operating temperature.
2.
Turn the idle adjustment screw in or
out until the engine idles at the
recommended RPM.
3.
Engine idle RPM is 1800.
4.
Adjust the idle to the correct RPM.
Make sure the engine is at normal
operating temperature before
adjusting the idle RPM.
THROTTLE CABLE ADJUSTMENT
The throttle has been adjusted
at the factory, and no
adjustment should be necessary.
If adjustment is necessary, the
following procedure should be
followed:
1.
Pull back rubber boots to
access cable adjustment nut.
2.
Loosen jam nut to allow
cable adjustment nut to be adjusted.
3.
Turn cable adjustment nut clockwise to increase free-play in the cable.
Turn the adjustment nut counterclockwise to decrease free-play in the
cable.
4.
There should be approximately 6 mm (1/4 in.) free-play in the cable.
AIR FILTER
The air filter inside the air filter housing must be kept clean to provide
good engine power and gas mileage. If the ATV is used under normal
conditions, service the filter at the intervals specified. If operated in
dusty, wet, or muddy conditions, inspect and service the filter more
frequently. Use the following procedure to remove the filter and inspect
and/or clean it.
JAM NUT AND CABLE
ADJUSTMENTNUT
THROTTLE LEVER
GOVERNING SCREW AND
JAMNUT
MEASURE FREE
PLAY HERE
IDLE ADJUSTMENT
SCREW
