CONTROL LOCATIONS AND FUNCTIONS
Ignition Switch
The ignition switch has two positions.
OFF position – All electrical circuits
are off. The engine will not start.
The key can be removed in this
position.
ON position – The ignition circuit is
complete and the engine can run.
The key cannot be removed in this
position.
Caution: Always leave the ignition switch in the OFF position
when
engine is not running.
Hand Brakes
The hand brakes should be applied whenever a braking situation is
needed. Apply the brakes by compressing the brake levers toward the
handle bar.
Brake Lever Locks
To engage and release a brake lever
lock, use the following procedure.
1.
Compress the hand brake lever.
2.
Depress and hold the brake lever
lock.
3.
While holding in on the brake
lever lock, compress the brake
lever.
Note: It will click as it engages and the brake lever will not return to its
released position.
Check to make sure the brake lever lock engages properly and that the
brake (when engaged) locks the wheels.
1.
Engage the brake lever locks.
2.
Attempt to push the ATV.
Note: The brake lever locks must lock the wheels. If they don’t adjust
the cables until the brakes lock and the wheels do not move.
BRAKE
LEVER
LOCK
HAND BRAKE LEVER
