Warning: Always check to be sure that the brake lever locks have been
disengaged before operating the ATV. An accident could result if a
brake lever lock is left engaged while the ATV is operated. The brake
may relax if left engaged for a long period of time. This could cause an
accident; therefore, do not leave the ATV on a hill depending on the brake
lever lock for more than one hour. Always block the downhill side of
the wheels if leaving the ATV on a hill or park the ATV in a sidehill
position.
Emergency Stop Switch
Emergency Stop Switch—This button
will stop the engine. The engine can
be started again by pressing the yellow
start button..
OFF position—The ignition circuit is
off. The engine can not be started or
will not run. If the emergency stop
switch is used to stop engine without turning off ignition switch, the
battery may discharge.
RUN position—The ignition circuit is on. The engine can start and run.
Electric Starter Button
Pushing in on this button activates the starter motor. Before starting the
engine, make sure the ignition switch is in the ON position, and the brake
lever locks are engaged.
Throttle Lever
Control engine RPM with the
position of the throttle lever..
Operate this lever with the thumb.
Pushing it forward increases engine
RPM and allowing it to retract
decreases engine RPM.
THROTTLE
LEVER
START
SWITCH
