Access 3260 Series, Installation & Operational Instructions

8

USER SHOULD

 periodically flush operating system (not to exceed 90 days). As a minimum, shall consist of filling and running 

system and draining. Access Tubs recommends flushing with a mild solution of water and sanitizer such as chlorine or other 
commercially available whirlpool bath flushing products.

DO NOT

 use abrasives. They may dull or scratch surface of the acrylic.

DO NOT

 use oil based solvents. Clean with only a damp cloth or mild detergent or any common glass cleaner.

DO NOT

 use bubble bath while the whirlpool is operating.

DO NOT

 turn on pump without water in the bathtub. To do so may cause damage to the pump.

DO NOT

 alter the position of the pump. To do so may void your warranty.

FOR MINOR SCRATCHES

The procedure to remove light surface scratches or burnish marks is quite easy. Simply apply rubbing compound to the affected 
area and buff lightly. Then apply paste wax and gently buff again to return the original shine.

REPAIR TO THE SURFACE

Should a deep scratch or more serious damage be encountered, please call Technical Service at Access Tubs for assistance. 
When calling, please have the serial number, date of purchase, and color of your tub.

CLEANING RECOMMENDATIONS
To clean the pipes and pump:

Fill the tub and pour a cup of bleach (or dishwasher soap [i.e. Cascade] if bleach is not available), run pump for five (5) minutes 
and let it sit for ten (10) minutes. Run the pump for five (5) minutes, then rinse two (2) times. Wipe off the surface after the rinse 
because the bleach may discolor some color trimmings.

After using bleach or dishwasher soap, you should follow this cleaning procedure:

Fill the tub with water and run the pump for 5 minutes, then rinse it 2 times. Clean with a soft damp cloth, do not use abrasive 
cleaners as they may scratch and dull surface of the unit.

PROBLEM

Pump not starting
Pump humming but not priming
Pump not moving water
No jet pressure
Leak in plumbing

SOLUTION

Check wiring; Check the on/off switch; Check water level; Reset GFI at outlet.
Air trapped in line; Check for clogged jets. Add water, may have to open top union.
Possible obstruction in impeller. Possible frozen clutch (requires replacement).
Clogged jet; air control not open; jet not open; missing part in jet.
Call Tech Service:  877-249-2388

NOTE:

 Caustic drain openers will damage the surface and the pump! Extreme heat from portable heaters

and cigarettes can damage the surface of the tub. 

DO NOT USE OIL BASED BATH ADDITIVES.

USER MAINTENANCE

TROUBLESHOOTING