Access MONTANA, Installation Manual

6

MONTANA INSTALL ATION MANUAL

BATH FITTING

1

   Before the bath is in its final position identify the 

best position for the taps, mark and drill the bath as 

needed. Install the waste and overflow to the bath.

2  

Remove and dispose of the wooden 

transportation board/pallet but 

KEEP THE FOUR 

SLOTTED FOOT BRACKETS

� See 

FIG. 4

�  

NOTE

It is imperative the bath is correctly  

level in all planes, as any distortion will cause  
the seal around the door to leak.

3  

Offer bath to required position and place into 

exact position� Level using the feet situated in 

each bath corner only

� Place the rear slotted  

foot brackets with the slots positioned so that  

the bath may be slid out of position and the  

foot mounting brackets left in place�

NOTE

Ensure the slot in the bracket is facing out. 

4  

Mark fixing centres for the brackets, remove the 

bath leaving brackets in place� Fix rear slotted  

feet brackets securely to the floor. See 

FIG. 5

�

5  

Slide the bath back into position and adjust the 

four corner feet to level the bath� Do this by 

loosening the top locking nuts beneath the  

frame, then use the bottom nuts to adjust the 

height until the bath is level� Tighten the top 

locking nuts into place once again� Offer up the 

foot brackets to the front feet and fix securely  

to the floor, locking the middle nut to the foot 

brackets to secure bath� See 

FIG. 6

�

6  

Secure the two support feet by loosening the  

top nuts, lower the feet until they are sitting  

on the floor and taking the weight of the bath. 

Once in position lock off the two top nuts�

 Check the bath is level and ensure that 
the weight is evenly carried. 

Transport 
board/pallet

Slotted foot 
bracket

Wall

FIG. 4

FIG. 5

FIG. 6

Slotted feet brackets

 Support feet