Accessmatic Accesslink AL39, User Manual

ATTENTION! If you want to program AL3900U directly in our receiver Omni - Pulse, you need to set following DIPS switches positions in 

the remote and receiver:

Opening your life

MANUAL AL3900U

TECHNICAL FEATURES 

Model AL3900U

1 Battery 2032 (3V)

Frequencies 300 - 900 Mhz ü

3 Channels  

Special Chip  

IN AL3900U THE USER CAN PROGRAMME DIFFERENT BRANDS AND FREQUENCIES IN EACH BUTTON JUST FOR SEQUENTIAL FLASH 

MODE 

ENTERING DIRECTLY THE RECEIVER MODE  

PROGRAMMING INSTRUCTIONS 

1. Locate the selector switch in the back of the remote. Retire the cover to expose the selector switch and the hidden button, see image 

below. 

2. Set your selector switch of 8 DIPs switchwith the desired brand. See Table 1 and image below.

3. Head for your receiver, in case it has DIPs switch, this defines the code of this specific receiver, please select this same combination from 

the receiver in the transmitter AL3900U.

C, both must match, otherwise the communication between them will not work. In case your receiver doesn’t have this DIP selector, this 

section must be ignored, it is not neccessary.

4. The remote is ready to be used, press any button (from 1 to 3) please refer to your receiver’s user manual. 

AL3900U

Omni - pulse

Seed button

Brand selector