www.acclima.com DataSnap/SnapView
User Manual
5
Blinking = Data is moving in or out of the USB port or the SDI-12 Port.
Error (Red)
OFF = No errors
ON = Short circuit or high current on SDI-12 PWR. The SDI-12 Voltage will drop until the condition is repaired.
Single Blink = SDI-12 communications failure.
SnapView Software & Driver Installation
The SnapView software must be installed prior to connecting the Data Snap to the computer. The Data Snap requires a Windows
™
driver to be installed before use. The driver is installed during the installation of the SnapView software.
Once the software is installed, connect the Data Snap to the computer via a USB cable. Windows
™
will automatically detect the new
Data Snap hardware and will attempt to find the appropriate driver. This driver installation process will only occur once per Data
Snap. Each new Data Snap will follow the same process.
Installing the SnapView Software
IMPORTANT NOTE! Be sure to install the SnapView
™
software before connecting the DataSnap to your PC’s
USB port!
Insert the CD into the CDROM drive on the
computer and click ‘Install Software’
on the window that appears. The Acclima SnapView
software and all required hardware drivers will install. Follow the on screen directions and accept the default options during the
installation.
Figure 2
Installing the driver on Windows
™
When the Data Snap is first connected to the computer, it will automatically be detected and the installation of the driver will begin.