www.acclima.com DataSnap/SnapView
User Manual
9
Figure 11
–
Basic wiring diagram
•
When connecting many sensors to one DataSnap, a wire splice may be necessary. This can be done by connecting all the
red sensor wires to a separate, single wire and then connecting the single new wire to the terminal block in the appropriate
position. Follow the same procedure to connect the white and blue wires. The wiring should look like figure 12. When the
block is connected to the DataSnap, the location of the colored wires must match the colors on the DataSnap.
Figure 6
–
Terminal Block Plug-in
Figure 7
–
Extended wiring splice example
