Quick Reference Guide
Page 6 of 12
Revised: October 21, 2004 @ 9:55 AM
How to LOAD Clips (CUE)
.
Before loading a clip, be sure at least one video channel is ACQUIRED on the Abekas 6000 control panel and select the
channel you wish to load a CLIP ID into. For example press the
C h A
button. The lamp below the CHANNEL button
should be illuminated GREEN — if not, follow the procedure “To ACQUIRE a Video Channel ”, starting on page 2 above.
1. Press
the
green
C L I P P L A Y
button (this is necessary only if the lamp below the button is not already illuminated).
2. On the numeric keypad, type a 1- through 7-digit CLIP ID that you wish to load.
3. Press the specific CHANNEL button (
C h A
,
C h B
,
C h C
, etc.). The defined CLIP ID is now loaded
into that specific video channel.
•
Alternative Method
1. Press
the
green
C L I P P L A Y
button (this is necessary only if the lamp below the button is not already illuminated).
2. Press the specific CHANNEL button (
C h A
,
C h B
,
C h C
, etc.).
3. On the numeric keypad, type a 1- through 7-digit CLIP ID that you wish to load.
4. Press
the
C L I P I D
button.
How to PLAY Clips
.
1. Press
the
green
C L I P P L A Y
button (this is necessary only if the lamp below the button is not already illuminated).
2. Press the specific CHANNEL button (
C h A
,
C h B
,
C h C
, etc.), which has the CLIP ID loaded that
you wish to PLAY.
3. Press
the button. The clip will PLAY to the end.
How to GO TO START of Clip (RECUE)
.
To instantly go to the START frame of the currently loaded clip (RECUE):
1. Press + . This will instantly cue to the starting frame of the clip.
How to GO TO END of Clip
.
To instantly go to the END frame of the currently loaded clip:
1. Press + . This will instantly cue to the end frame of the clip.
