Configuring the Switch
3-162
3
Selecting the Queue Mode
You can set the switch to service the queues based on a strict rule that requires all
traffic in a higher priority queue to be processed before lower priority queues are
serviced, or use Weighted Round-Robin (WRR) queuing that specifies a relative
weight of each queue. WRR uses a predefined relative weight for each queue that
determines the percentage of service time the switch services each queue before
moving on to the next queue. This prevents the head-of-line blocking that can occur
with strict priority queuing.
Command Attributes
•
WRR
- Weighted Round-Robin shares bandwidth at the egress ports by using
scheduling weights 1, 2, 4, 6 for queues 0 through 3 respectively. (This is the
default selection.)
•
Strict
- Services the egress queues in sequential order, transmitting all traffic in the
higher priority queues before servicing lower priority queues.
Web
– Click Priority, Queue Mode. Select Strict or WRR, then click Apply.
Figure 3-90 Queue Mode
CLI
– The following sets the queue mode to strict priority service mode.
Console(config)#queue mode wrr
4-199
Console(config)#exit
Console#show queue mode
4-202
Queue mode: wrr
Console#
Summary of Contents for 24/48 10/100 Ports + 2GE
