Command Line Interface
4-28
4
enable password
After initially logging onto the system, you should set the Privileged Exec password.
Remember to record it in a safe place. This command controls access to the
Privileged Exec level from the Normal Exec level. Use the
no
form to reset the
default password.
Syntax
enable password
[
level
level
]
{
0
|
7
}
password
no enable password
[
level
level
]
•
level
level
- Level 15 for Privileged Exec. (Levels 0-14 are not used.)
• {
0
|
7
} - 0 means plain password, 7 means encrypted password.
•
password
- password for this privilege level.
(Maximum length: 8 characters plain text, 32 encrypted, case sensitive)
Default Setting
• The default is level 15.
• The default password is “super”
Command Mode
Global Configuration
Command Usage
• You cannot set a null password. You will have to enter a password to change
the command mode from Normal Exec to Privileged Exec with the
enable
command (page 4-20).
• The encrypted password is required for compatibility with legacy password
settings (i.e., plain text or encrypted) when reading the configuration file
during system bootup or when downloading the configuration file from a TFTP
server. There is no need for you to manually configure encrypted passwords.
Example
Related Commands
enable (4-20)
authentication enable (4-77)
Console(config)#enable password level 15 0 admin
Console(config)#
Summary of Contents for 24/48 10/100 Ports + 2GE
