Command Line Interface
4-184
4
Example
The following example shows how to set the interface to port 1 and then enable
ingress filtering:
switchport native vlan
This command configures the PVID (i.e., default VLAN ID) for a port. Use the
no
form to restore the default.
Syntax
switchport native vlan
vlan-id
no switchport native vlan
vlan-id
- Default VLAN ID for a port. (Range: 1-4094, no leading zeroes)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• If an interface is not a member of VLAN 1 and you assign its PVID to this
VLAN, the interface will automatically be added to VLAN 1 as an untagged
member. For all other VLANs, an interface must first be configured as an
untagged member before you can assign its PVID to that group.
• If acceptable frame types is set to
all
or switchport mode is set to
hybrid
, the
PVID will be inserted into all untagged frames entering the ingress port.
Example
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport ingress-filtering
Console(config-if)#
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
Summary of Contents for 24/48 10/100 Ports + 2GE
