Command Line Interface
4-196
4
show gvrp configuration
This command shows if GVRP is enabled.
Syntax
show gvrp configuration
[
interface
]
interface
•
ethernet
unit
/
port
-
unit
- This is unit 1.
-
port
- Port number. (Range: 1-26/52)
•
port-channel
channel-id
(Range: 1-4)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Example
garp timer
This command sets the values for the join, leave and leaveall timers. Use the
no
form to restore the timers’ default values.
Syntax
garp timer
{
join
|
leave
|
leaveall
}
timer_value
no garp timer
{
join
|
leave
|
leaveall
}
• {
join
|
leave
|
leaveall
} - Which timer to set.
•
timer_value
- Value of timer.
Ranges:
join: 20-1000 centiseconds
leave: 60-3000 centiseconds
leaveall: 500-18000 centiseconds
Default Setting
• join: 20 centiseconds
• leave: 60 centiseconds
• leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console#show gvrp configuration ethernet 1/6
Eth 1/ 6:
GVRP configuration: Enabled
Console#
Summary of Contents for 24/48 10/100 Ports + 2GE
