Management Guide
2-27
Parameter
Description
Accept Default
Allow the default route to be updated via the console or a router running
Route Updates
BGP (Border Gateway Protocol).
Use Split Horizon
1
Never propagates routes back to an interface port from which they have
been acquired.
Use Poisoned Reverse
1
Propagates routes back to an interface port from which they have been
acquired, but sets the distance vector metrics to infinity.
Send Triggered
Whenever a route gets changed, broadcast an update message after
Responses
1
waiting for a short random delay, but without waiting for the periodic cycle.
1: These are methods used to prevent loops that would cause endless retransmission of data traffic.
ARP Table
This table shows the IP-to-physical address mappings discovered via the
Address Resolution Protocol.
+------------------------------------------------------------------------------+
| ES3616 CheetahSwitch Workgroup-3616
switch_a
|
| ~witch Management/Advanced Management/L3 IP Networking/ARP Table
admin
|
+------------------------------------------------------------------------------+
+--------------------------------------------------------------+
|
Internet Address
Physical Address
VLAN ID
Type
|
+--------------------------------------------------------------+
| |210.68.150.108
0800095C2540
1 (0x001)
dynamic
|
| |210.68.150.118
0000E8363769
1 (0x001)
dynamic
|
+--------------------------------------------------------------+
--------------------------------------------------------------------------------
<UpArrow><DownArrow>Move <+>Add <->Delete <s>Search
<ESC>Previous
Parameter
Description
Internet Address
IP addresses for which ARP has resolved the physical address.
Physical Address
MAC address corresponding to the listed IP address.
VLAN ID
The VLAN group this host belongs to.
Type
Indicates if the address was resolved dynamically through ARP or was
defined via static mapping.
Notes
: 1. You can search for a specific entry by typing “s” and entering an Internet
address or physical address. If the address is found, it will be highlighted
in the table.
2. To add a static entry, press the “+” key, then enter the Internet address
and corresponding physical address.
3. To delete an entry, first highlight the required entry with the cursor and
press the “-” key.
Summary of Contents for ES3616
