1
A-1
Appendix A: Troubleshooting
Refer to the Installation Guide for a more detailed listing of troubleshooting
procedures. However, if you have trouble making a connection to the agent
module, then please refer to the following section.
Console Connection
If you cannot access the on-board configuration program via a serial port, be
sure to have set the terminal emulator program to VT100 compatible, 8 data bits,
1 stop bit, no parity and 19200 bps. Also check that the null-modem serial cable
conforms to the pin-out connections provided in Appendix B. The default
password is null. However, if you forgot or lost the password, contact Accton
Technical Support for help.
In-Band Connection
You can access the management agent on the switch from anywhere within the
attached network using Telnet, a Web browser, or other network management
software such as AccView. However, you must first configure the switch with a
valid IP address, subnet mask, and default gateway. If you have trouble
establishing a link to the management agent, check to see if you have a valid
network connection. Then verify that you entered the correct IP address. Also
check the network cabling that runs between your remote location and the
switch.
Note
: Only one Telnet connection is supported. If you cannot connect, someone else
may already be attached to the switch via Telnet.
Summary of Contents for ES3616
