531
E
ES4710BD 10 Slots L2/L3/L4 Chassis Switch
suppliant. Equivalent to CLI command 20.2.2.12.
z
Holddown time for authentication failure(1-65535 second) - Configures suppliant quiet-period
status time after authentication failure. Same as CLI command 20.2.2.13.
z
Re-authenticate client interval(1-65535 second) - Configures time interval of switch
re-authentication client. Equivalent to CLI command 20.2.2.14.
z
Resending EAP-request/identity interval(1-65535 second) - Configures time interval of switch
retransfer EAP-request/identity frame to suppliant. Equivalent to CLI command 20.2.2.15.
z
EAP relay authentication mode - Configures switch to adopt EAP relay method to make
authentication; use the “no” command to configure switch to adopt EAP local terminating
method to make authentication. Equivalent to CLI command 20.2.2.4.
z
MAC filtering – Enables, disables the switch dot1x address filter function. Equivalent to CLI
command 20.2.2.6.
Example: Choose 802.1x status as Open 802.1x, Configure Maximum retransmission times of
EAP-request/identity as 1, choose Re-authenticate client periodically as Disable Re-authenticate,
configure Holddown time for authentication failure as 1, configure Reauthenticate client interval as
1, configure Resending EAP-request/identity interval as 1, choose EAP relay authentication mode as
forbid, choose MAC filtering as forbid and then click Apply button to set the configurations.
20.5.2.2 802.1X port authentication configuration
Click “Authentication configuration”, “802.1X configuration”, “802.1X port authentication
configuration” to Configure port 802.1x function
z
Port – assigns port
z
802.1x status – port 802.1x status, Open, 802.1x function is open; Close, 802.1x function is
close. Same as CLI command 20.2.2.5.
z
Authentication type - Configures port 802.1x authentication status. Auto means enable 802.1x
authentication. According to switch and suppliant authentication information, to confirm that
the port is in authenticated status or unauthenticated status, force-authorized is configured port
as authenticated status, allowing unauthenticated data to pass across the port; for
force-unauthorized configure port unauthenticated status, switch not provide suppliant
authentication service in this port, not permit any port pass across this port. Same as CLI
command 20.2.2.9.
