84
E
ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Run the Telnet client program included in Windows with the specified Telnet target.
Fig 4-8 Running the Telnet client program included in Windows
Step 3: Log in to the switch
Log in to the Telnet configuration interface. Valid login name and password are required, otherwise
the switch will reject Telnet access. This method protects the switch from unauthorized access. If no
authorized Telnet user has been configured, nobody can connect to the Telnet CLI configuration
interface. As a result, when Telnet is enabled for configuring and managing the switch, username
and password for authorized Telnet users must be configured with the following command:
telnet-user <user> password {0|7} <password>
Example: Assume an authorized user in the switch has the username of “test”, and password of
“test”, the configuration procedure should like the following:
Switch
>en
Switch#config
Switch(Config)#telnet-user test password 0 test
Enter valid login name and password in the Telnet configuration interface, Telnet user will be
able to enter the switch’s CLI configuration interface. The commands used in the Telnet CLI
interface after login are the same as in the Console interface.
