Novell NetWare
21
Configuration Settings
This section describes the configuration settings which can be altered in your Print
Server. To make changes, use PSCONFIG or the programs described in
Chapter 8 -
Management Tools.
Configuration using PSCONFIG
To use PSCONFIG to change the device settings, the procedure is as follows.
1.
Run PSCONFIG; a list of Print Server units will appear.
2.
Select the Print Server you want to setup, then press [E
NTER
].
3.
Select
Change Configuration. A list of category configurations will appear.
4.
Select the category you want to edit, then press [E
NTER
].
5.
Select the item you want to edit and press [Enter]. If you are prompted to enter a
character string, enter a string.
6.
Change any other items you wish. The [E
SC
] key will return you to main menu to
select another category if you wish.
7.
Select
Execute Change and press [E
NTER
] to save the configuration changes to
the Print Server.
General Device Settings
The following configuration changes can be made, regardless of which Network
protocol or operating systems is being used. :
•
Get Print Server Information
•
Reset Print Server
•
Restore Default Configuration
•
Change the Print Server’s name.
•
Change the device password.
•
Disable/Enable network protocols.
•
Get Printer Status (idle, off-line, printing)
•
Logical Printer Setup (see page 24)
•
Define logical printer
•
Set pre-print-job string.
•
Set post-print-job string
•
Serial port configuration (if exists):
•
Baud rate
•
Handshake protocol
•
Stop bits
•
Data bits
•
Parity.
