System Settings
4-4
4
Administrator Settings
The Administrator Settings page enables you to change the default password for
management access to the RG230.
Figure 4-5 Setting a Password
Current Password
– You need to first enter your current administrator password to
be able to configure a new one. (Default: admin)
New Password
– Enter a new administrator password. (Range: 3~12 characters)
Confirm New Password
– Enter the new password again for verification.
(Range: 3~12 characters)
Auto-Logout Time
– The time of inactivity after which the unit terminates a web
management session. (Default: 30 minutes; Range: 1~99 minutes)
Firmware Update
The Firmware Update page enables you to download new software to the unit.
Figure 4-6 Firmware Update
Firmware Update
– Downloads an operation code file from the web management
station to the RG230 using HTTP. Use the Browse button to locate the code file
locally on the management station and click Apply to proceed.
Summary of Contents for RG230
