VoIP Settings
7-6
7
Figure 7-3 Call Features
Call Waiting
– Enables a call waiting alert. If during a call there is another incoming
call, an alert tone is heard. You can place the active call on hold (press the “Flash,”
“Flash Hook,” or “Hold” button on the phone) and switch to the incoming call.
(Default: Disabled)
Call Waiting Timeout
– The time a second incoming call waits before a “no answer”
message is sent. (Range: Must be less than or equal to the value of Answer
Timeout; Default: 30 seconds)
Always Forward Phone Number
– Another phone number to which all incoming
calls are forwarded.
On Busy Forward Phone Number
– Another phone number to which incoming
calls are forwarded when the phone is busy.
No Answer Forward Phone Number
– Another phone number to which incoming
calls are forwarded when there is no answer.
Call Forward No Answer Timeout
– The time a call waits for an answer before
being forwarded to the No Answer Forward Phone Number. (Range: Must be less
than or equal to the value of Answer Timeout; Default: 10 seconds)
Summary of Contents for RG230
