System Configuration
5-38
CLI Commands for System Logging – To enable logging on the
access point, use the
logging on
command from the global
configuration mode. The
logging level
command sets the
minimum level of message to log. Use the
logging console
command to enable logging to the console. Use the
logging host
command to specify up to four Syslog servers. The CLI also
allows the
logging facility-type
command to set the facility-type
number to use on the Syslog server. To view the current logging
settings, use the
show logging
command.
AP(config)#logging on
6-24
AP(config)#logging level alert
6-26
AP(config)#logging console
6-25
AP(config)#logging host 1 10.1.0.3 514
6-24
AP(config)#logging facility-type 19
6-27
AP(config)#exit
AP#show logging
6-28
Logging Information
============================================
Syslog State : Enabled
Logging Host State : Enabled
Logging Console State : Enabled
Server Domain name/IP : 1 10.1.0.3
Logging Level : Error
Logging Facility Type : 16
=============================================
AP#
Summary of Contents for WA6102X
Page 27: ...Hardware Installation 2 4 ...