Quick Installation Guide
4
Hardware Installation
1.
Select the Site – Choose an appropriate place for your Wireless Bridge/Access
Point. In general, the best location is at the center of your wireless coverage
area, within line-of-sight of all wireless devices. Try to place the Bridge/AP in a
position that can best cover its BSS. (refer to page 14). Normally, the higher you
place the antenna, the better the performance. (See page 20 for the maximum
distances allowed between clients and the Bridge/AP.)
2.
Attach the Antenna – Screw the antenna into the antenna connector
(ANTENNA) on the back panel.
3.
Connect the Ethernet Cable – The 10BASE-T Ethernet port on the Bridge/AP
can be connected to a network device such as a hub or a switch. Connect
Category 3, 4 or 5 UTP Ethernet cable to the RJ-45 socket on the back panel.
4.
Connect the Power Cable – Connect the power adapter cable to the 9 VDC
power socket on the rear panel.
Caution:
Use ONLY the power adapter supplied with the WB3001A. Otherwise, the
product may be damaged.
Antenna
Connector
Reset
Button
DC 9V
Power Cable
RJ-45
Connector
RS-232 Port
Summary of Contents for WB3001A
