42
Settings
Farbe: P 249 – Prüfmittelnummer: 203
43
Settings
3
The procedure for changing the settings is as follows:
O
The settings have a fixed sequence and are displayed consecutively,
see illustration on the previous page.
O
Press the S button to call up the settings.
A test strip is not advanced.
O
Press the M button to change the setting that is currently flashing.
Numbers such as the year are incremented by one. Pressing and
holding down the button increments the number quickly.
From the highest selectable number, pressing the M button auto-
matically takes you to the lowest one.
In the case of settings where there are a number of options, such
as the beep tone setting, pressing the M button presents each
option in turn.
O
Press the S button to save the chosen setting and move on to the
next setting.
O
You can change any setting at any time. Press the S button repeat-
edly until the setting you wish to change is displayed flashing.
O
From the last setting “Hypo indicator” pressing the S button takes
you back to the first setting “Beep tone/Acoustic Mode”.
O
You can close the settings at any time by pressing the Test button.
All settings you have entered up to that point are saved.
Notes
i
Always
turn the meter on with the S button when you intend to
change the settings.
Instead, if you turn the meter on with the Test button and there is
a drum in the meter, a test strip will be advanced.
i
If you turn the meter off with the Test button, it shows you the
number of test strips remaining in the drum (see Chapter 2.3.2).
i
The meter turns off automatically after approximately 60 seconds
if you do not press a button. All settings you have confirmed up to
that point with the S button are retained. Settings that you have
not confirmed with the S button are lost and the original setting
remains.
