3002 MICROSCOPE SERIES
ACCU-SCOPE
®
73 Mall Drive,
Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
17
LED Lamp Specifications
The 3002-LED-R microscope is equipped with a variable 1 watt rechargeable LED lamp. The LED lamp can
last up to 5 hours on a single charge depending on the brightness level used, and is rated for 10,000 hours.
The battery should come fully charged from the factory. To recharge the battery, follow the instructions
below.
NOTE:
The microscope can be used while recharging the battery with the power cord, and it can still operate
with the power cord when the battery can no longer hold a charge and needs to be replaced.
If the LED lamp or battery needs to be replaced, contact your local authorized ACCU-SCOPE dealer or call
ACCU-SCOPE at 631-864-1000 for a dealer near you.
LED Lamp Assembly
CAT# 02-3259
; Battery Pack
CAT# 02-1060
-- available only through authorized
ACCU-SCOPE dealers.
LED Illumination
(For Corded or Cordless Operation)
Cordless Operation
To use the microscope for cordless operation (battery only), unplug
the power cord from the wall and from the base of the microscope.
Turn the power switch to the on “I” position.
The battery light indicator
on the front of the microscope base will
be green when the battery is charged, and turns red when the
battery is running low.
Corded Operation
(While Recharging the Battery)
You can recharge the battery
while continuing to use the
microscope
. Turn the main switch
on the base of the
microscope to the off “O” (middle) position, connect the power cord
to the base of the microscope and plug the cord into a power supply
outlet. Turn the main switch
to the on “I” position.
It takes about 5-6 hours to fully recharge the battery.
NOTE:
The battery light indicator
will be remain red while the
power cord is plugged in and charging while using the microscope.
Once the power cord is removed, the light will turn green to indicate
the battery is fully charged.
Recharging the Battery
To recharge the battery
without using the microscope,
turn the
main switch
on the base of the microscope to the off “O” (middle)
position, connect the power cord to the base of the microscope and
plug the cord into a power supply outlet. Turn the main switch
to
the “recharge” position “II”. It takes about 5-6 hours to fully recharge
the battery. The battery light indicator
will be green when
charged.
②
NOTE:
When your microscope is
not in use, turn the main switch
on the base of the microscope to
the off “O” (middle) position to cut
off all power (battery and AC).
