![background image](http://html1.mh-extra.com/html/accu-scope/exc-500/exc-500_user-manual_3732920011.webp)
EXC-500 MICROSCOPE SERIES
ACCU-SCOPE
®
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
11
ADJUSTMENT & OPERATION
Powering On -
(Fig. 13)
With the microscope plugged in, locate and push the I/O
toggle button
①
on the back of the microscope to the ON
(I) position.
Powering On LED Illuminator
& Adjusting Brightness -
(Fig. 14)
Push the illuminator On/Off button to turn on the transmitted
light
①
.
Adjust the brightness by turning the Iluminator Adjustment
Knob
②
clockwise for brighter illumination, counter clockwise
for less illumination.
Placing A Specimen -
(Fig. 15)
Push the left side of the Specimen Holder
①
on the top of the
stage place to open the holder. Place your slide in and
release the holder to allow it to close firmly against the slide.
Adjusting the Stage -
(Fig. 15)
The stage has a coaxial X-Y Stage Movement Knob
①
which
allows you to move your specimen in any direction: top knob -
forward/back (Y), and bottom knob - left/right (X).
Adjusting the Stage Tension -
(Fig. 16)
The stage control tension can be adjusted according to user
preference. To adjust the tension, pull the bottom Stage
Movement Knob
①
down to expose the tension adjustment
rings
②
for the X-Y direction.
To loosen, turn each ring counter-clockwise, or clockwise to
tighten.
Push the bottom knob up when you reach the desired tension.
①
Fig. 13
Fig. 14
①
②
Fig. 15
Fig. 16
①
②
①
②