AXIOM™ 400 Product Manual
Safety
2-3
02-AXIOM400-Safety_R10.doc
Accu-Sort Systems, inc.
Compliance Requirements
FCC NOTICE:
The Axiom has been tested and found to comply with the limits
for a Class A digital device, pursuant to
Title 47, Part 15
of the
FCC Rules
.
These limits are designed to provide a reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manuals, may cause
harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
WARNING:
These are Class A products. In a domestic environment, these
products can cause radio interference, in which case the user may be
required to take adequate measures. (Ref. CISPR 22 = EN 55 022:1995.)
IMPORTANT:
Follow the guidelines below to maintain Electromagnetic
Compatibility (EMC) Compliance:
§
Interconnecting cables must be twisted pair cables.
§
All shielded I/O cables shall have the shield terminated to the chassis.
§
NOTE: DRAIN WIRE SHIELDING IS NOT ADEQUATE.
§
Do not remove the shielding covers.
§
Refer to the details on making custom cables as provided in the specific
technical manual for the component.
Electrical Safety
Axiom must be installed in accordance with Canadian Electrical Code, Part I,
CSA C22.1; CSA C22.2 No. 0; and the National Electrical Code, NFPA 70. For
complete requirements, National Electrical Code, ANSI/NFPA 70, Canadian
Electrical Code, Part I, C22.1, or other national standard must be consulted.
§
For PERMANENTLY CONNECTED EQUIPMENT/RACK MOUNTED,
incorporate a readily accessible disconnect device
in the fixed wiring.
§
For PLUGGABLE EQUIPMENT/RACK MOUNTED, install the socket-
outlet near the equipment so it is easily accessible.
§
Make sure that all personnel who work with the equipment know where
the disconnect switches or circuit breakers are located.
§
Before performing any type of maintenance, turn off power to the unit
and disconnect the power cord.
§
Be certain your hands and the floor of your work area are dry before
touching electrical equipment or connecting cords.
§
Routinely check all power cords, plugs, wiring, and cable connections for
any signs of exposed wire or deteriorating insulation. If you notice any
damage, make arrangements with service personnel to repair or replace
the damaged item immediately.
Summary of Contents for AXIOM 400
