14
loosening the locking screw on top of the tool bars so that
the bars will move freely when the calibrated knobs are
turned.
3.
Adjust cutter bars to remove the minimum amount required
to finish the rotor in one cut. DO NOT MACHINE A ROTOR TO
LESS THAN MANUFACTURER'S SPECIFICATIONS.
4.
If surface is scored, locate the deepest score and turn the
rotor micrometer knob until the tool bit bottoms out at the
deepest point of the score; zero the scale and back out the
tool bit. Repeat on other side. If no score exists, touch
rotor with tool bit near outer edge and advance calibrated
hand knob until full circle is scratched on rotor and "O"
knob. Back out the tool bit.
Numbers 5-6 instructions on next page.
Summary of Contents for 8944
