16
ACCU 1500
Layout
Operator’s Manual
4.1-1
4.1
The display.
Refer to Figure 4.1-1.
Note:
Positions related to the internal (left) plane
of the wheel are labeled with a number
followed by “a”, while for external (right)
plane positions the number is followed by
“b” (e.g.: 1a, 1b).
1.
Weight Application Position (WAP) indicator.
As the corrective weight position on the wheel
reaches 12:00, all weight application position (WAP)
indicator lights will illuminate confirming that you
have located the position for weight application. All
weights will be applied at 12:00 with all WAP lights
illuminated.
2.
Display.
Depending on the stage of the program the display
gives the operator information about rim sizes, bal-
ancing weights, error codes, etc.
3,7
Weight position indicator.
Fit a clip-on weight at the rim position indicated when
the relative WAP indicator lights up.
4,5,6
Weight position indicator.
Fit a stick-on weight at the rim position indicated
when the relative WAP indicator lights up.
8
Motorcycle Dynamic and Static Indicator.
The indicator lights up when you activate the mo-
torcycle wheel balancing program or the single
weight (static mode).
9
PAX wheel Indicator.
The indicator lights up when you activate the PAX
SYSTEM wheel balancing mode.
4.1.1
Audible System signals.
Possible beeps:
High:
the unit returns a short high beep at the start of the
balancing cycle. or after activating a key. Refer to
Chapter 4.2.
Low:
the unit returns a low beep if an error is detected,
usually together with a system message indicating
the nature of the error.
For all other audible beeps, refer to Chapter 7, as these
indicate errors.
4.1
The display.
Refer to Figure 4.1-1.
Note:
Positions related to the internal (left) plane
of the wheel are labeled with a number
followed by “a”, while for external (right)
plane positions the number is followed by
“b” (e.g.: 1a, 1b).
1.
Weight Application Position (WAP) indicator.
As the corrective weight position on the wheel
reaches 12:00, all weight application position (WAP)
indicator lights will illuminate confirming that you
have located the position for weight application. All
weights will be applied at 12:00 with all WAP lights
illuminated.
2.
Display.
Depending on the stage of the program the display
gives the operator information about rim sizes,
balancing weights, error codes, etc.
3,7
Weight position indicator.
Fit a clip-on weight at the rim position indicated
when the relative WAP indicator lights up.
4,5,6 Weight position indicator.
Fit a stick-on weight at the rim position indicated
when the relative WAP indicator lights up.
8
Motorcycle Dynamic and Static Indicator.
The indicator lights up when you activate the
motorcycle wheel balancing program or the single
weight (static mode).
9.
PAX wheel indicator.
The indicator lights when the PAX SYSTEM tyre
balancing programme starts.
10.
User selector display.
A numeric sequence on the display indicates which
user is enabled to use the balancing equipment at
that moment.
11.
User selector button.
User data can be stored by pressing firmly the user
button.
By pushing button, system scrolls all the users.
