Cleaning and Maintenance
&
G
etting S
tar
ted
1
2
3
4
Attention!
Clean the unit with the power OFF, only.
Do not use chemicals/abrasives to clean the
unit.
Since the sensors in this unit are of the optical type,
miscounting may be caused if paper particles, dust,
dirt, stain, and other materials get stuck or clutter the
counting sensors. Also, it may be difficult to start the
counting operation if the repeat and/or the auto-start
sensor are cluttered with dust, paper particles, etc.
For effective operation of the unit, it is necessary to
clean all the sensors shown in the picture on the left
with a dry brush, periodically or as needed.
Due to the optical nature of the sensors in the unit,
exposure to any direct light source should be avoided.
Since the machine uses a roller friction system, keep
small objects such as pins, clips, necklaces or hair
away from it to prevent them to get stuck in the
mechanism. Clean the hopper and stacker with a dry
brush or cloth, periodically or as needed.
It is important to keep the UV lamp clean by pulling
and pushing the UV lamp cleaning-shaft.
SENSORS
