10
Unpacking, etc.
•
After removing the packing materials, check the appearance of the dispenser for possible defects or
irregularities. If the product shows any irregularity in its appearance, contact the distributor.
•
All the packing materials (straps, box, Styrofoam, wood, etc.) should never be left within the reach of
children and should be disposed of according to local regulations.
•
For safety, the product should be installed and used with caution in accordance with the User’s
manual.
•
Incorrect installation or careless use of the product may damage or injure the environment, humans,
animals, and/or materials and property. The manufacturer does not bear any responsibility for the
aforesaid damage or injury.
• The dispenser performs best at room temperature of 50~75°F and a supply of water at 50°F.
•
The dispenser should only be installed indoors and should NOT be installed near heat generators such as heaters,
stoves, or dishwashers
Product Installation
Where there is
no heat source
.
※
Install in a place where there is no heating device
such as a fireplace or a gas range and do not install in an
area outside the range of 10 ~ 38
℃
/50 ~100
o
F.
Allow
enough ventilation
•
For normal operation, install the dispenser at least 4
inches away from the back wall and 6 inches above the top
of the dispenser.
※
Never block the upper vents and do not place any
load on it.
•
Poor ventilation will decrease the unit’s ability to
make ice.
Install on
a flat
surface
※
Unstable installation may cause vibration and noise.
The recommended angle of installation is 1
o
•
A flat surface is recommended because there is a
possibility that the product will fall and cause injury when
the installation is made in a sloping place.
•
Installation should be indoors in a clean place
•
The drain hose should be installed at an angle so that drainage is good.
•
During installation and use, water leakage may occur due to various reasons. It must be used at a
place where drainage facilities are fully equipped
•
When installing the product indoors (places such as living room, store, the floor where damage
may occur due to leakage), please install natural drainage facilities and waterproof the floor.
•
Even when installing in the kitchen, a drain hole must be provided, and a drain hose must be
connected.
•
The manufacturer shall not be held responsible for the spreading damage caused by insufficient
drainage facilities in case of the above-mentioned problems and problems due to water supply hose
deviation or breakage.
Summary of Contents for AIWD160
