12
Requirements for power supply
120VAC, 60Hz, 15-amp circuit breaker and electric power are required. A separate circuit is required for
grounding.
The power cord of the product should be inserted into a suitable 3-prong grounding-type socket.
Important Information: A Ground Fault Circuit Interrupter (GFCI) is not recommended because it could cause
the operation of the product to stop.
Important Information: The provisions of the National Electric Code as well as any local laws and instructions
should be observed when installing the product.
Electrical Connection
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For personal
safety, this appliance must be properly grounded. The power cord of this appliance is equipped with a 3-
prong grounding plug that mates with a standard 3-prong grounding wall outlet to minimize the possibility
of electric shock hazard from the appliance. Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is
encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong
wall outlet. The dispenser should always be plugged into its own individual electrical outlet which has a
voltage rating that matches the rating label on the appliance. This provides the best performance and also
prevents overloading house wiring circuits which could cause a fire hazard from overheated wires. Never
unplug your dispenser by pulling on the power cord. Always grip the plug firmly and pull straight out from
the outlet. Repair or replace immediately all power cords that have become frayed or otherwise damaged.
Do not use a cord that shows cracks or abrasion damage along its length or at either end. When moving
the ice maker, be careful not to damage the power cord.
Extension Cord
Because of potential safety hazards under certain conditions, it is strongly recommended that you do not
use an extension cord with this dispenser.
Warning!
Do not use extension cords or 2-prong adapters. The product must be grounded.
Never cut off the grounding terminal of the 3-prong grounding plug.
Summary of Contents for AIWD160
