7
For model CT66JL:
1.
Unscrew the lower hinge and take off the door.
2.
Push the kick plate to the right in the new position.
3.
Undo the upper hinge fastener and fix it to the opposite side of the housing, where you have
already removed and replaced the fastener with the hole to the opposite side.
4.
Put the door on the upper hinge fastener.
5.
Fix the lower hinge in the new position.
6.
Unscrew the handle and place it on the opposite side.
7.
Some screws are covered with caps. Take off these caps before undoing the screws.
8.
Check the gasket. It should not be creased and should seal well.
Door Handle Installation
The door has two screw holes on each side, allowing you to install a handle (included). To do so,
align the handle with the screw holes on the side you prefer. Fix the handle in place with the
included screws, then cover the screw heads with the handle seal (included).
