7
CAUTION: After unpacking you MUST let this appliance stand upright for at least 2 hours to allow the
lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so
may adversely affect performance and the lifetime of this unit.
Installing the Shelves
CAUTION: Do not stock your appliance until the shelves are correctly installed inside the unit with
shelf clips.
Your refrigerator contains 6 metalic shelves and
corresponding shelf clips.
To install shelves, first place the shelf clips in the slots
in the pilasters in the cabinet interior. Use the numbers
on the pilasters as a guide in placing the clips at the
same distance from the cabinet floor, with the tab
pointing up as shown. Once all clips are in place,
install the shelves by placing them on the clips, with
the outside bar of the shelf on the inside of the clip
tabs. Keep all stored items inside the limits of the
shelves. These allow airflow and should not be blocked
when product is stocked in the unit.
NOTE:
To avoid accidents when cleaning inside the unit, first remove the shelves and shelf clips.
Electrical Connection
Proper electrical installation is required for your refrigerator to function correctly and to prolong the
useful life of electrical parts and compressor.
BEFORE CONNECTING UNIT FOR FIRST TIME:
1.
Verify that line voltage does not fluctuate more than 10% above the nominal value of 120 V,
60 Hz.
2.
DO NOT use extension cords.
3.
DO NOT connect refrigerator to multiple plugs or plugs with another appliance connected.
4.
The unit MUST be plugged into a grounded socket.
