7
Electrical Connection
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a
three-prong plug that mates with a standard three-prong wall outlet to minimize the possibility of
electrical shock. Do not under any circumstances cut or remove the third ground prong from the
power cord supplied.
This unit requires a standard 115-volt AC/60Hz electrical outlet with three-prong ground. Have the
wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the unit and not left exposed or
dangling.
The unit should always be plugged into its own individual electrical outlet having a voltage rating that
matches the rating label on the appliance. This provides the best performance and also prevents
overloading house wiring circuits that could cause a fire hazard from overheated wires.
Never unplug the unit by pulling on the power cord. Always grip the plug firmly and pull straight out
from the receptacle. Repair or replace immediately any power cord that has become frayed or
otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at
either end. When moving the unit, be careful not to damage the power cord.
Extension Cord
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance
Reversing the Door Swing
The door swing of both of these units cannot be reversed in the field. When ordering in the future,
always specify whether you need a right hand or left hand (option “LHD”) door swing. All units ship
with a right-hand door swing unless specified differently at the time of order.
Door Handle Installation
The door has two screw holes on each side, allowing you to install a handle (included). To do so,
align the handle with the screw holes on the side you prefer. Fix the handle in place with the
included screws, then cover the screw heads with the handle seal (included).
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
