Instruction Manual SP 2-6-0 M-6
Electrical Pickup
Your Accucraft model is powered by
the DC voltage off the track through
the engine and the tender. All driv-
ers are insulated on the both side of
the locomotive, and the electricity is
picked up with 12 pickup wheels.
Be sure to clean electrical pickup units
before each operation. Replacement
electrical pickup units can be ordered
from Accucraft Trains.
Lighting
This model features directional light-
ing.
General Maintenance:
Clean the exterior surfaces of your
locomotive with a clean, soft and lint
free cloth. To remove stubborn soil
or greasy spots from the painted sur-
faces use alcohol on a soft, lint free
cloth.
Accucraft Trains locomotives are fine
scale brass models with small parts.
To provide maximum protection from
shipping damage, we carefully pack
the models in metal cases, We ship
via UPS with insurance coverage to
its full valve. Please contact UPS if
package is damaged.
Each locomotive is packed under
UPS guidelines for shipping. We do
not warrant any damage resulted from
re-packing by any party other than
Accucraft Trains
.
5
Instruction Manual SP 2-6-0 M-6
6
Please read following directions be-
fore unpacking your locomotive.
1. Remove foam around the locomo-
tive. Slide the inner box cover to the
side, and open the inside cardboard
box with a cutting knife.
2. Lift the metal case from the card-
board box.
3. The locomotive is fi rmly taped to a
½” wood board which is then fastened
to the metal case with 4 M6 bolts.
Bolts must be removed before lifting
the locomotive with wood board from
the metal case.
4. Place taped locomotive on a fl at
surface. Carefully cut the tape along
the wood board side surface. Be sure
to cut both sides of the wood board.
Slowly lift the tape from the locomo-
tive. Be very careful with small parts.
Tape cannot be re-used to re-pack the
model. Use new packing tape if nec-
essary.
